#define X_MAX_LENGTH 252 #define Y_MAX_LENGTH 227 #define EXT0_HEAT_MANAGER 1 #define EXT0_PID_PGAIN_OR_DEAD_TIME 19.58 #define EXT0_PID_I 1.71 #define EXT0_PID_D 55.94 Note: for my own Anet A8, I had to change the following parameter too, because otherwise X=0 was 6mm to the right from the edge of the bed.Īnd a couple of more parameters. Open the Repetier.ino located in the “src\ArduinoAVR\Repetier” sub folder where you extracted the Repetier firmware, and compile & upload it from the Arduino IDE. Just download it from, extract it and run “Skynet V2\arduino-1.6.9-slim\arduino-1.6.9\arduino.exe”.
The easiest way to do it, is to use the Arduino IDE bundled with Skynet3D firmware (it's preconfigured for Anet A8). Next, you have to compile the source to binary hex file using the Arduino IDE. Before you can compile and upload the firmware, you need to select the board and port. Start the IDE and go to File->Open and select the file Repetier.ino in the repetier subdirectory. Download the file and unpack the contents. #define MAX_ACCELERATION_UNITS_PER_SQ_SECOND_X 400 #define MAX_ACCELERATION_UNITS_PER_SQ_SECOND_Y 400 #define MAX_TRAVEL_ACCELERATION_UNITS_PER_SQ_SECOND_X 800 #define MAX_TRAVEL_ACCELERATION_UNITS_PER_SQ_SECOND_Y 800 All you need is to download the contents as a ZIP file. #define MAX_ACCELERATION_UNITS_PER_SQ_SECOND_X 1000 #define MAX_ACCELERATION_UNITS_PER_SQ_SECOND_Y 1000 #define MAX_TRAVEL_ACCELERATION_UNITS_PER_SQ_SECOND_X 2000 #define MAX_TRAVEL_ACCELERATION_UNITS_PER_SQ_SECOND_Y 2000 Then open the “src\ArduinoAVR\Repetier\Configuration.h” with Notepad, and changeĪ good idea is to also change the accelerations to lower values to prevent vibrations. Go to the “boards\Zonestar P802M” sub folder, and copy the Configuration.h file to “src\ArduinoAVR\Repetier” folder. Unzip the archive when downloaded, and open the directory. Go to, click “Clone or Download”, and then “Download ZIP”.
#Repetier server upload install
To install Repetier firmware on Anet A8, you must first download it.
0 kommentar(er)
